Call now to get tree assist such as tree cleanup, tree clearance, bush drop, shrub fall, stump lop and much more around USA:


Call us now

Call +1 (855) 280-15-30










Attachments Attachments.

Gringer Mixer Gringer Mixer.

the slickest way if your handy with a welder is to wipe all grease out of the spindle, so it will not burn you, then run several beads of weld at low heat onto the inside of the bushing, let it cool on its own and the weld will shink and loosen the bushing allowing you to use a hammer and bar to drive it out, use low heat, you only want the weld on the inside of the bushing, not weld the.

This message is a reply to an archived post by soundguy on March 22, at The original subject was Re: spindle bushing removal. You could use the tool made for the job, and have an easy time of it. Jan 21, Spindle bushing removal discussion in the Ford forum at Yesterday's Tractors. Spindle bushing removal - Ford Forum - Yesterday's Tractors Jump to. For tractors the lower spindle bushing is" ID. The" ID tool is not in this set. Made for classic Ford 2n, 8n, 9n and many others fits spindle and kingpin bushings.

Massey Ferguson 50, 65, and fits spindle bushings but not king stumpcutter.buzz date: May 10, Wide Front Axle Spindle Bushing R1 If you have a Farmall H, M or Super H or M with tie rods that are in front of the axle, then please view IHS for the correct spindle bushing. " outside diameter" inside diameter" overall length 4 used per tractor Sold individuallyNote: May need to ream to size. Massey Ferguson Spindle Bushing\Bearing\Seal Kit - Kit includes (4)M1 bushings, (2) X thrust bearings, and (2) M1 spindle dust seals.

For tractor models, 50, (Part No: SBBSKIT02)Apr 23, Tractors - Antique & Classic.

Hydraulic Oil Filter.

Ford-N-Fordson. Spindle key. Jump to Latest Follow 1 - 19 of 19 Posts. G. Jan 21, Spindle bushing removal discussion in the Ford forum at Yesterday's Tractors. Spindle bushing removal - Ford Forum - Yesterday's Tractors Jump to. This message is a reply to an archived post by soundguy on March 22, at The original subject was Re: spindle bushing removal.

You could use the tool made for the job, and have an easy time of it.