Call now to get tree assist such as tree cleanup, tree clearance, bush drop, shrub fall, stump lop and much more around USA:


Call us now

Call +1 (855) 280-15-30






If the bushing is incorrectly installed it will tear while incorrectly performing.

Nov 15, Your going to need a 18mm thru 21mm wrench's and sockets, remove the brake caliper,rotor, your have to remove the tension strut from the knuckle,strut from the lower control arm,lower control arm from the knuckle.

I've decided that since I have to take so much stuff apart and everything else is now, or will soon be in need of repair, I'm just going to replace all bushings and ball joints.

your going to have to use a jack under the knuckle to hold it so when you bust loose the knuckle from the lower control arm you can hold it while Estimated Reading Time: 1 min. Apr 25, However, it looks like even after I get that piece out, I still will not have room to accomplish the removal of the old bushing sleeve or the installation of the new bushing (already in a sleeve).

So, after re-reading RT's post below, it looks like I need to keep on taking things apart until I have completely removed the lower control arm. Apr 07, For removing and installing press-in bushings without removal of the control arm. Fits most Ford, GM and Chrysler rear wheel drive vehicles.

Includes step-by-step usage instructions and photos showing the tool in use. Instruction sheets are laminated to resist staining and are permanently fastened to the case/5(5). Jun 20, I have been using a ball joint press to remove the bushings. It just seems easier to setup than the press, and the ball joint press has a bunch of adaptors with it. It is the OTC kit, but the down side is it costs more than the Hydraulic press. If getting a press, get the ton is't only 50 more than the ton.

mopar dodge lower control arm bushing removal. Dec 16, To remove the lower control are the following must be done: 1. remove the belly pan (mm bolts) and the lower front fascia.

Once aligned insert the control arm mounting bolts by hand to avoid cross threading.

There ara a series of 9/32 bolt-screws and about 6 snap pins. 2. Use an 18mm ratchet/socket to remove the two drivers side bolts holding the steering rack/pinion in place and loosen the right one. There are two bolts on the left side. The. Wireless Headphones. Receive wireless headphones and a chance to get more prizes. Redeem Now. MP3 Player.

Receive a MP3 player and a chance to get more prizes. Redeem Now. LIMITED OFFER: There is limited stock. Redeem while supplies last.