Call now to get tree assist such as tree cleanup, tree clearance, bush drop, shrub fall, stump lop and much more around USA:


Call us now

Call +1 (855) 280-15-30






Solving Intonation Problems free.

May 24, Heating the tuner bushing softens the lacquer underneath and helps prevent chipping when removing. Do that by heating the bushing. Just hold a soldering iron against it. You don't want it to be red hot or anything, but a bit of heat evenly through the bushing will soften the lacquer under it.

Use a cloth to prevent scratching.

This makes it a safer job to remove the stumpcutter.buzzted Reading Time: 2 mins. Quickly and easily remove bridge and tailpiece bushings or hard-to-remove knobs from your guitar using this handy tool.

The rubberized bottom helps avoid com. Jun 28, A guitar bushing puller is really handy for this. This is mine. You’ll notice a rather crudely cut hole in the side of it. That’s actually really important because, as you start to remove a bushing, it can often pull on lacquer or even wood around it as it lifts.

Thanks a lot.

That can cause nasty chipping. May 20, How to Remove Tune-o-Matic Bushings From Les Paul Style Guitar: This is a quick and easy way to remove Tune-O-Matic bridge and tail piece bushings from a Les Paul style guitar.

This instructable will show how to make a cheap and easy to use tool that can be used to remove the bushings for repair and for repaint Estimated Reading Time: 2 mins. The bolt cost about 1 from home depot. The screw I already had here. The bolt's size is Mx70mm. The 50mm or 60mm length ones would have worked fine.

Tailpiece bushing removal tip: In some cases, especially with Gibson guitars, the tailpiece bushings are installed before the guitar is finished. To avoid chipping the finish, we recommend scoring the bushing with a sharp knife. For stubborn bushings, careful heat from a soldering iron will help break them free. Instructions and bolts for. The bolt's size is Mx70mm. The part # on mine is if anyone wants to use my exact one from Home Depot.

After a moment of clarity (and trials,) I figured out a way to remove the ferrules from the back of my Ibanez I use a duplex nail, small hammer, and pl.